[Jeff], fully acknowledging his inability to keep plants alive, has designed a system to help him out a little bit. The “Plant Whisperer” monitors water levels and notifies him if the plant needs attention. Actually, it notifies him either way. The plant whisperer uses real time text to speech to say one of several pre-programmed things, either proclaiming its happiness or requesting more water. He’s using a parallax propeller for the job as he says it is capable of handling the real time text to speech. We realize this is overkill, but we absolutely love it. The only improvement we would want would be to possibly use a pre-recorded voice for more clarity.  You can see a video of it in action after the break.

When [Deddies lab] was looking to keep their (rather large) Ficus Lyrata appropriately watered, they followed their motto, stuck a micro controller on it and whipped up an Electronic Watering Can .

The whole thing starts off with power that is switched on once a day for 15 minutes by a traditional mechanical lamp timer, and that is connected to a atmega8 micro controller running @ 1MHz which increments a counter by one. When that counter hits 7 the mega switches on a pump, watering the plant with roughly half a liter of water per week out of a bucket reservoir , which according to the article’s calculations should last about 4 months.

In order to assure that the pump does not run out of water a rubber duck was attached to a string, the other end is attached to a micro switch, and when the water gets too low the string is pulled, switching one of the micro controller’s pins low.

While we agree that it could use a low water indicator, that is trivial to add, and over all the project represents a great hack done on a Sunday using parts and materials already on hand. Join us after the break for a quick video too!

The back story behind [Mike] experimenting with plants as AM radio transmission antennas antennae is rather interesting and worth the short read. But for those who just want the facts, [Mike] took an ATMega324, modified the PWM output into a sinusoidal AM signal (using a simple form of RLC circuitry), and connected the circuit to a plant no plants were harmed in the making of this project. The results? Well we’re not ones who would spoil the surprise, you’ll have to see for yourself in the video after the jump.

Like many specialty plants, growing mushrooms requires that you keep a fine balance between humidity and temperature. this can be fairly tedious at times, so many opt for automated systems. [Anthony_p1234] has chosen to build his own.  Using an Arduino, he controls power to two heating pads, a sonic humidifier, and an air pump to keep his mushrooms happy. He shares the process of building the system, testing and calibrating the parts and putting it all in use. We didn’t see any schematics, but he does describe everything fairly well. The source code is available for download.

The author had a broken tux toy laying around and wanted to do something fun with it. He cut a hole in the front to mount an LED matrix and connected it all to an Arduino. A couple of metal rods serve as a resistivity sensor in the plant’s dirt.

When you water the plant, tux flashes some hearts and a smiley face. As the moisture drops, tux gets less happy with the end result being a big frown.

These are the same people who brought you the Arduino Photolab.

[via Hack a Day Flickr Pool]

You can make pretty much anything a speaker by vibrating it. Japanese engineer, [Keiji Koga], has been working for many years to perfect his plant based sound transmission system. The voice coil is at the bottom of the plant container and transfers sound up the stalk to the leaves. It’s and interesting idea, but we can’t imagine it sounds much better than vibrating a rigid surface.

[via io9]