[Jeri] threw down the geeky fashion gauntlet by building this LED enhanced dress. She chose to assemble the project for her trip to BarBot 2011, and we can’t think of a more appropriate setting for such a garment. It uses a motion sensor to set off a delayed pattern of blue lights hidden underneath the fabric.The best part of the hack is the instamatic camera. It looks like a fashion accessory, but it’s really hiding all of the circuitry for the lights.

Inside the camera a PIR sensor waits until it detects motion, sending a signal through an op-amp to the trigger circuitry. A 74LS14 Schmitt Trigger chip teams up with some resistor-capacitor timer circuits to build a delay chain for the LEDs. This way, after motion is detected the LEDs come on and off in a staggered pattern that doesn’t require a microcontroller and is very pleasing to the eye. See the Analog win for yourself after the break.

Instructables user [MacDynamo] was thinking about home security systems and wondered how much electricity is being wasted while such systems are powered on, but not activated. He pondered it awhile, then designed a circuit that could be used to turn a security system on or off depending on the time of day, but without using any sort of clock.

His system relies on a 555 timer configured as a Schmitt trigger, with a photoresistor wired to the reset pin. When the ambient light levels drop far enough, the resistance on the reset pin increases, and the 555 timer breaks out of its reset loop. This causes the circuit to power on whatever is connected to it. When the sun rises, the resistance on the reset pin drops and the 555 timer continually resets until it gets dark again. He notes that this behavior can be easily reversed if you were to put the photoresistor on the trigger pin rather than the reset pin.

We like the idea, though we are a bit wary about using this for any sort of real security system. An errant insect or debris could cause the system to be turned on, and we’d feel pretty foolish if someone disabled our alarm with a flashlight. That said, this sort of circuit still has plenty of practical, power-saving applications outside the realm of home security.

[Aris] has quite a few MIDI devices that only have in and out ports. To chain together multiple devices, the MIDI slaves must have a “thru” port. Instead of daisy chaining, a better solution is to build a thru box to split the signal from the master. [Aris]‘s thru box design uses an optocoupler on the input, which connected to 74HC14 hex inverting Schmitt trigger. The schematic shows three outputs, but there’s room for adding two more. A useful bit of kit for only a two hour job.