[Chris] says that he’s been pretty busy lately, leaving little opportunity for hacking. However he did manage to find a little time to put together a small project that has occupied his to-do list for a while – a floppy drive music controller.

We have seen hacks that use microcontrollers to actuate floppy drive motors before, but we can’t remember anything that used a calculator to do the job instead. While a microcontroller gives you plenty of I/O pins to play with, [Chris’] Ti-83+ only has two.

Even with the calculator’s I/O limitations, he didn’t find the task too overly difficult as he merely needed to hold a pair of the drive’s pins low, while pulsing two others. He modified a media player written for Ti calculators to output the necessary control signals, then he cranked out some tunes.

As you can see in the video below, his simple setup works quite well – not bad for just a few hours’ work.

Global CALCnet lets you connect your TI graphic calculator to the Internet and use your favorite services like instant messaging and Internet relay chat. It also provides the option of worldwide multiplayer functionality for games ported to the device such as Scorched Earth and Tetris. We looked in on [Christopher Mitchell's] CALCnet in December when it was being used to create local area networks with the adding machines. He’s taken that up a notch with a helping hand from Arduino. An Arduino board is used to connect the serial communications from the calculator to an Internet connected PC via the Arduino’s USB capabilities.

Think this will waste a lot of time in schools? Unlikely since an Internet connected computer is integral for this system to work. If you have a computer in front of you why waste time on the calculator network? Still, how hard would it be to build a WiFi module that can directly connect them to an access point? That may be a moot point as the Slashdot article that pointed us to global CALCnet also links to a calculator port of DOOM. It runs quite well, as you can see in the video after the break. This is a must-have for anyone owning a TI Nspire that can run it.

[Thanks Rlyeh_Drifter]

[Greg] was feeling nostalgic about the game RACE for to TI-83 graphing calculator. In the game, your car is stationary with controls to move the scrolling maze from side to side in order to avoid a crash. He set out to build a physical version of the game with a don’t-touch-the-side concept that reminds us of Operation.

The game board is a wire frame constructed from paperclips then attached to a motorized frame. The vehicle is also metal and is attached to the lens sled from a scrapped CD-ROM drive. The maze scrolls from left to right with up and down vehicle motion controlled by two arcade buttons. An Arduino controls the motors and monitors the button inputs. He has plans to add a buzzer that sounds when the metal car “crashes” in to the wire walls of the maze. We’ve embedded video of the working game after the break. For more build photos take a look at his flickr set.

[via Lifehacker]