ANT+ Networks Using An MSP430 Chip And Android Phone

[Jbremnant] wanted to try his hand with ANT+ wireless networks. This protocol is designed for light-weight and low-power consumer electronics, like heart rate chest straps and bicycle computers (Garmin brand devices for example). There are already libraries out there for Arduino, but [Jbremnant] found that most of them were written as slave-only code. He set out to use an MSP430 to drive a fully functioning ANT network including a computer and an Android phone.

The TI Launchpad is used as the master node in the network. [Jbremnant] chose the smaller of the two MSP430 processors that came with the dev platform. After starting down this road he realized that chip didn’t have a hardware UART needed to communicate with the SparkFun ANT board (based on the nRF24AP1 radio chip). Rolling with the punches, he used a software UART he had previously worked with. Now he’s able to transmit test data from the Launchpad. It is picked up by both a USB dongle on his computer and the Android phone seen above. Check out his demo video after the break.

[youtube=http://www.youtube.com/watch?v=ck9I86ENKLI&w=470]

5 thoughts on “ANT+ Networks Using An MSP430 Chip And Android Phone

  1. hey , i want to interface my android with the receiver of my aerial vehicle that uses a x bee module , i.e. i want th e gravity sensor of my android to control my aerial vehicle ….

    help if possible

Leave a Reply to RobotCancel reply

Please be kind and respectful to help make the comments section excellent. (Comment Policy)

This site uses Akismet to reduce spam. Learn how your comment data is processed.