GNU Radio For Space (and Aircraft)

GOMX-3 is a CubeSat with several payloads. One of them is a software defined radio configured to read ADS-B signals sent by commercial aircraft. The idea is that a satellite can monitor aircraft over oceans and other places where there no RADAR coverage. ADB-S transmits the aircraft’s ID, its position, altitude, and intent.

The problem is that ADS-B has a short-range (about 80 nautical miles). GOMX-1 proved that the signals can be captured from orbit. GOMX-3 has more capability. The satellite has a helical antenna and an FPGA.

The people behind the satellite, GomSpace, has a complete parser for the ADS-B data beacons and [destevez] has it rolled into a GNU Radio module. There’s a good representation of captured data on a map in [destevez’s] blog post. If you want something less interactive, you can see a static map of all collected data. If you want to try your hand at picking up GOMX-3, you can hear it transmitting in the video below.

We’ve talked a lot about CubeSats in the past and ADS-B monitoring (the link is broken, but the video still works). If you want a GNU Radio primer, we’ve done that, too.

10 thoughts on “GNU Radio For Space (and Aircraft)

    1. Distance has a lot to do with aircraft elevation, and with obstructions such as trees and buildings. Line-of-sight can go a long way under suitable conditions. 80 nautical is for reliable and repeatable operation in most weather conditions. That is why a satellite works so well for ADS-B reception — no LOS obstructions and no nearby EMI interference. It may also depend on relative antenna orientations between the aircraft and your receiver. Perhaps a helical antenna such as used on the cubesat may give you even further distance to (some, but not necessarily all) aircraft.

      1. Indeed, ADS-B signals have plenty of power. A satellite should have a very large line-of-sight range. However, the 1090MHz ES downlink is saturated in most areas with a busy airspace. A sat might thus require quite a bit of DSP to get useful results.

  1. A quick look around das webs suggests that ADS-B antennas are often mounted on the bellies of airplanes. Bearing in mind the difference in altitude, the satellite would almost *need* to be a few hundred km downrange for the body of the aircraft to not be directly in the signal path.

  2. Isn’t there something called ADSB-C that is the satellite uplink from planes? I read somewhere someone tapped in to the C-band downlink and cracked the protocol with the help of a low cost SDR.

  3. I have an ADS-B set-up that has a home made co-linear antenna made out of semi-ridged feeding a high pass filter and a good LNA that’s mounted about 20 feet up on the eave of my house with a cheap SDR dongle at the PC end and I’m getting over 200NM out of high altitude planes. I bet if I had everything in the RF string at the antenna and then fed the USB portion down from the eave, I could really reach out there.

Leave a Reply to geekmaster Cancel reply

Please be kind and respectful to help make the comments section excellent. (Comment Policy)

This site uses Akismet to reduce spam. Learn how your comment data is processed.