CNC 3020 Router Gets A Power Supply Upgrade

June 1, 2014 by Rich Bremer 32 Comments

CNC3020 Router power supply upgrade

We’ve covered these CNC 3020’s in the past. They are physically solid machines but the electronics offer some room for improvement. [Peter] is certainly no novice at working on these machines. He’s already fixed a failed power supply and he’s back at the upgrades, again focused on the power supply. This time he’s replacing the transformer-based one with a couple switching power supplies.

The stepper controllers and spindle speed circuit need both 48 and 24 VDC. [Peter] purchased two separate power supplies, one for each voltage required. Before installing the new supplies, the stock one had to be removed, along with the transformer. Even with the old parts removed, there was still not enough room for both new supplies to be installed inside the stock case. [Peter] decided that mounting them to the top of the case would be appropriate.

Continue reading “CNC 3020 Router Gets A Power Supply Upgrade” →

Overkill Phone Charger, Because, Well, Why Not?

May 27, 2014 by Rich Bremer 26 Comments

ATX Phone Charger

There are times in a tinkerer’s existence where it is convenient to have the ability to plug in and power a lot of USB devices. Sure, you could use a USB hub but this may not be satisfactory if your devices require a lot of current. A computer may work but is not really a stand alone solution.

[Jeff] and the crew over at Make Lehigh Valley ran into this predicament. They were putting on an Adafruit Trinket class and needed a USB power supply to power all of the Trinkets that were going to be used. As any makerspace would do, they built their own USB Power Station, and the final product is certainly overkill for what they needed (that’s not a bad thing).

An old ATX computer power supply is a logical component to use for this type of project. These power supplies are usually available in abundance and will provide all the amperage any reasonable amount of 5v USB devices can ask for. The 5v output from the ATX power supply was wired to 8 USB jacks. Keeping up with the project’s resourcefulness, those USB jacks were scavenged from a couple of old PCI-slot USB hub panels. Not satisfied with only USB outputs, the guys also wired up some banana jacks so that 3.3, 5 and 12 volts were available for whatever project was being worked on. A 3D printed enclosure keeps everything neat and tidy.

This project used a bunch of recycled parts and solved a problem faced by the group. If you’re interested in using an ATX power supply to make a more bench-top style power supply then check out this build.

Switchmode Power Supply Hacking (power Your Laser)

July 27, 2007 by Will O'Brien 7 Comments

[Mike] wanted a better power supply for his argon laser, so he modded some switchmode power supplies. With a few tweaks, he had a few adjustable voltage outputs and a nice solid supply of electrons for his laser projects. If you need a lab quality adjustable power supply for your projects, this is a nice way to get it on the cheap. (He’s in the UK, but the same ideas should apply to us models.