If you thought there wasn’t anything else to shove on the end of your iPod, [Alex] is here to set you straight. He used the DC power that’s available on the iPod’s dock to drive a cheap laser pointer. It’s pretty easy to do – just get a dock connector (sparkfun has em) and add a laser pointer module. If you’d rather access everything else, check out the super dock I put together a while back. Hit the read link if you’d rather see the picture in color.
ipod hacks171 Articles
Internal Bluetooth For 5th Gen IPods
[Ed] sent in his latest iPod modding effort. Previously he did this on a 4th gen, and now he’s following that up with a 5th gen version. He found an even smaller bluetooth module for the mod, but it requires replacing the hard drive with a compact flash card to make room inside the case if you want to keep the original back cover.
DIY IPod DAC Modding
Red Wine audio offers the iMod – a service that modifies the DAC in 4th, 5th and 5.5th generation iPods. Despite requiring some fine work, the mod isn’t that difficult. [joneeboi] sent in his DIY DAC mod how-to, and even better, it’s suitable for 3rd gen and 1st gen Nanos. The audio signal is tapped directly after the DAC, and the SMD capacitors in the iPod are replaced with high end Black Gate capacitors. This is just the mod feed the best possible signal to your headphone amp
IPhone GPS Module
The boys over at engadget put this up while I was working it over, but I’m still gonna hit it. [Curt] sent in the iPhone GPS he put together. He’s using a micro-controller to send the ground toggle handshake we mentioned in the iPhone serial tutorial, along with a small NMEA serial GPS module. After the handshake is completed, the controller hands over the serial port to the GPS output. (Since the handshake only needs the ground toggle, I’d guess that the module is connected to the TX/RX lines all the time.) By the way, the GPS looks like this SiRF II board sold by spark fun electronics.
Mic Preamp In An IPod Touch Dock Connector
[Marian] sent in his sweet little Mic preamp that he built for his iPod touch. He built the circuit on the legs of a TLC272 OP-Amp with SMD components. The whole thing actually fits inside the cover of a standard iPod dock connector.
Bonus: [tnkgrl] added a USB bluetooth adapter to her eeePC after her circuit tracing efforts.
Upgrade Your In-ear Headphones
I’m a fan of my Etymotic er6i (which have mysteriously vanished…) headphones, so this simple hack caught my eye. [James C] sent in this simple method of upgrading the more affordable apple in ear headphones. The idea is simple, use a small hole punch to cut out the center of some cheap foam earplugs. Then replace the soft surrounds on the headphones with them. I’m guessing that this trick would work for quite a few in ear headphones that I’ve seen lately.
Simple IPhone Headphone Mod
Apparently the iPhone jack isn’t quite standard – it’s a bit recessed to the point that third parties are offering adapters for it. [John] offers this simple method for modding Etymotic’s fine ER6i headphones. (If only I could find mine. I haven’t seen them for 8 months.) I suggest using a utility knife over a pocket knife. It’s simple, easy, and will probably work on most headphones.