Touchscreen Scooter Computer

June 28, 2010 by Mike Szczys 38 Comments

[Kurt’s] scooter computer started off as a way to use a couple of LEDs to show the battery charge on his hog. It was based on a Arduino and used a voltage divider to judge how much juice was left. But then he ran across a touch-screen OLED shield for the Arduino and the project started to take off. Now he’s got battery, temperature, real-time clock, and GPS running through the slick-looking display. It may not be a full-blown motorcycle but it gives the computer interfaces we’ve seen for other bikes a run for their money.

[Thanks Mowcius]

Motorcycle computer

May 1, 2010 by Mike Szczys 21 Comments

Hackaday writer of yore [Will O’Brien] has been working on this hardware for his motorcycle. Speed, voltage, gear, and temperature data is displayed on a 16×2 character LCD. The speed is pulled from the bike itself and the gear is calculated by comparing engine RPM to wheel RPM. He’s using the popular DS1820 1-wire temp sensor along with an Arduino to pull everything together. At this point he estimates there’s about $50 worth of parts, but that can be reduced by etching a board and just using the necessary components.

Better Temperature Readings Using An Aspirated Thermometer

December 17, 2009 by Jakob Griffith 15 Comments

Unlike regular thermometers that can get incorrect readings because of the sun’s heat, shading, and airflow, aspirated thermometers isolate the temperature sensor from precipitation and the sun, while providing constant air circulation. Take ten 1-wire T2SS boards and combine them with DS18B20s and you’ve got yourself the start of an aspirated thermometer. A foot of PVC pipe, fans, and the above mentioned parts and you’ll have accurate temperature readings in no time.

[Dave] made his to control a natural gas boiler, pumps, and 11 gas-fired unit heaters for a combined output of 5.3 million BTUs per hour – keeping his greenhouse nice and toasty.

Update: Thanks Firetech for pointing out our silly typo.