This one is fitting – I was just checking out Suunto’s sweet gps data logging watches today. [Steve Cholewiak] sent in his diy GPS data logger. It uses an old DeLorme tripmate – these were serial gps units that ran off of internal batteries. A PIC controller reads the NMEA sentences from the tripmate. Then it stores the track data to an EEPROM. The same serial connection is used to retrieve the data later on. [Steve] did a great job writing this up, the circuit is pretty simple and he’s provided all the information you need to build your own.
eeprom72 Articles
Five Dollar Eprom Programmer
A couple years ago I spent a good week wiring up a fairly complex EPROM programmer so I could burn a prom for my jeeps EFI system. Today I ran across this $5 version. build built by Jay Kominek He uses shift registers to handle the addressing and IO lines, all driven directly by the parallel port. There’s no way to escape the number of pins that have to be wired up, but the schematic itself is pretty simple.
[By the way, arcade supply shops are a great source for cheap UV erase EPROMS.]
[Update: I’d forgotten about the voltage change (3 vs 5 if I remember) needed to write UV EPROMS vs EEPROMS. With a little mod, you can certainly use this for EPROMS as well.]
