Robot Lives In Your Garden And Eats The Weeds

You can’t deny the appeal of gardening. Whether it’s a productive patch of vegetables or a flower bed to delight the senses, the effort put into gardening is amply rewarded. Nobody seems to like the weeding, though — well, almost nobody; I find it quite relaxing. But if you’re not willing to get down and dirty with the weeds, you might consider deploying a weed-eating garden robot to do the job for you.

Dubbed the Tertill, and still very much a prototype, the garden robot is the brainchild of some former iRobot employees. That’s a pretty solid pedigree, and you can see the Roomba-esque navigation scheme in action — when it bumps into something it turns away, eventually covering the whole garden. Weed discrimination is dead simple: short plants bad, tall plants good. Seedlings are protected by a collar until they’re big enough not to get zapped by the solar-powered robot’s line trimmer.

It’s a pretty good idea, but the devil will be in the details. Will it be able to tend the understory of gardens where weeds tend to gather as the plants get taller? Can it handle steep-sided raised beds or deeply mulched gardens? Perhaps there are lessons to be learned from this Australian weed-bot.

Continue reading “Robot Lives In Your Garden And Eats The Weeds”

This Arduino Hookup Is Perfect For Microgrowery

to3H8Pa

All it takes is one little seed. One tiny little seed, that when planted into the ground and nourished correctly, can flourish into a healthy and happy plant. But there are some challenges involved. For example, maintaining a steady temperature and keeping moisture at an optimum level can be difficult at times, especially when just starting out.

This Arduino grow-op monitoring solution helps to solve those problems. It was built by [growershower] as a fun side project to monitor the vital signs of 3 marijuana plants. The board is an Uno and has an SD card shield with a DHT22 temperature sensor plus a soil moisture sensor. A photo diode is also used to measure light.

The graph produced from the data is a weed grower’s wet dream:

Continue reading “This Arduino Hookup Is Perfect For Microgrowery”

How To Make A Vaporizer For Smoking Medical Marijuana

Here’s a home made vaporizer we can really get behind.

Lets just take a second to be completely honest here. There’s no point in suggesting that this is possibly for smoking tobacco.  Medical marijuana is legal (well, not federally), in several states, and we’re sure there are hackers there that would really enjoy making something of their own instead of just buying something.

We’ve covered a few below and they always seemed to have something in common. They use soldering irons for heat. Inevitably someone points out what a bad idea this is.

Continue reading “How To Make A Vaporizer For Smoking Medical Marijuana”