[Christofer Hiitti] found himself with the latest Microsoft Flight Simulator on his PC, but the joystick he ordered was still a few weeks out. So he grabbed an Arduino, potentiometers and a button and hacked together what a joke-yoke.
The genius part of this hack is the way [Christopher] used his desk drawer for pitch control. One side of a plastic hinge is attached to a potentiometer inside a drawer, while the other side is taped to the top of the desk. The second pot is taped to the front of the drawer for pitch control and the third pot is the throttle. It works remarkably well, as shown in the demo video below.
The linearity of the drawer mechanism probably isn’t great, but it was good enough for a temporary solution. The Arduino Leonardo he used is based on the ATmega32u4 which has a built-in USB, and with libraries like ArduinoJoystickLibrary the computer interface very simple. When [Christopher]’s real joystick finally arrived he augmented it with a button box built using the joke-yoke components.
There’s no doubt that Microsoft Flight Simulator 2020 will spawn a lot of great controller and cockpit builds over the next few years. We’ve already covered a new joystick build, and a 3D printed frame to turn an Xbox controller into a joystick.
The build is fun, but the pitch mechanism is ingenious!
Ikea food clips have so much potential!
If it does the job, job done!
Neat temporary solution, cant deny that, but boo for making a f-ing vertical video.
That said i do enjoy how the Reddit embed thingy just goes “nope” and only shows the top 50% of the video, at least somebody in the reddit offices knows what’s up hehe.
if it was done in sideways mode he would have had to move the camera back another couple of meters to get the screen and “yoke” in the one image then either show all the junk he may have lying on his desk or crop it back into page mode again. but at a reduced resolution.
Yepp! My office is basically a walk closet, so there wasn’t enough room to get the shot any other way.
Roger, Roger, Over, Over, What’s my vector Victor….
Here I thought he converted his desk drawer at work, so the Boss wouldn’t see the yoke.
Strictly speaking this is at work also… At least during this pandemic.