Small CNC Gadget Draws What It Hears

September 12, 2010 by Mike Szczys 7 Comments

This art piece makes drawings based on sound. [Mario Marchese], who is responsible for those illusion props back in february, built this little guy out of a bunch of junk he had lying around. It features four microphones that listen to ambient sound and feed the signal through some LM386 audio power amplifiers. The output is translated into forward, backward, left, and right movements of the writing platform while the pen is fixed in the same position. Despite what we said in the title of the post this isn’t strictly a CNC machine, but more the primordial cousin of one.

Collect And Analyze ECG Data

August 22, 2009 by Zach Banks 14 Comments

ecg

Although we’ve covered DIY ECGs before, [Scott Harden] sent in his version that gives an in-depth explanation of what to do with the collected data. He built a basic battery-powered op-amp-based ECG for under $1. The circuit just amplifies the signal from the chest leads and feeds it into a computer via the microphone port. He then used GoldWave to record, filter, and save the signal. From there, he used python to analyze the heartbeat and calculate his heart rate and further manipulate the data. His previous blog posts go into more detail on how the python code works and why he chose software over hardware filters.

Stereo Microphones In An MSI Wind

June 1, 2009 by Caleb Kraft 14 Comments

binaurial

[Matt] wrote in to tell us about this project. He plans on travelling with his MSI Wind and wanted better audio recording capabilities. He decided to install an additional microphone and a preamp. He made a custom preamp and wired it directly to the motherboard. The microphone was then mounted in the laptop screen. The second microphone is placed opposite of the first, about 18cm apart which [Matt] claims gives it a binaural effect. We think that this might just classify as stereo though. Wouldn’t you have to seperate them with a barrier or dampening device for binaural? It doesn’t really matter though, stereo mics are a great addition to the MSI Wind, and he did it very well. He does point out that it picks up a lot of noise though. There’s always room for improvement.

Condenser Microphone Building

April 22, 2009 by Caleb Kraft 28 Comments

mic

Browsing around today, this project caught our eye. Mainly due to the visual similarity to, well, personal massagers. As it turns out, it’s a home made studio condenser microphone. We would generally prefer to link directly to his personal page, that has a slightly more in dept write up, but it has popups and pop unders, so enter at your own risk. Generally condenser mics require phantom power to make the magic happen, but he has included a circuit to run them off of 9v batteries. We’ve done condenser mics before, but this seems a bit quicker and dirtier.

Hydrophone

June 4, 2008 by Juan Aguilar 14 Comments

Chances are you’ve never wondered what your goldfish is trying to say, but if you have (or if you just want a project), check out this DIY hydrophone.

You will need a computer microphone, vegetable oil, plastic wrap, scissors, solder, and a small unused plastic bottle. Solder the mic capsule to an appropriate length of cable and test. The entire assembly can then be submerged in vegetable oil inside a plastic bottle. Yes, vegetable oil. Seal the bottle and you’re done.