Wearable Hacks

800 Articles

Wide Angle Lense Mod For The ATC2K

June 25, 2009 by 6 Comments

wal

For those that have them, the ATC2K action camera is a decent little piece of equipment. It is waterproof and can save video for roughly 30 minutes on a flash card. The viewing angle of the lens leaves something to be desired though. This has been remedied in newer models. [raalst] shows us how to modify the ATC2K to install a new, wider angle lens, while retaining the waterproof seal.  He also takes us through a necessary mod to ensure clear video under water since the new lens was not initially intended for it.  Just in case you are curious, he’s using his for hobby radio controlled submarine dives.

Things To Hack: Sub 100$ Toy Night Vision, Projector, And Tv Game

June 22, 2009 by 14 Comments

projector

Ars Technica writes about three new toys coming out this year: a sub 100$ projector, tv game, and night vision goggles. The projector runs at standard TV resolution, takes standard composite in, and outputs an okay picture. The night vision goggles are monocular but focus both eyes on a single RGB LCD. The goggles uses an array of IR LEDs instead of amplifying ambient light to see in the dark. Lastly, they have a standalone implementation of the arcade game Big Game Hunters. The rifle uses a sensor bar to do the motion tracking and features a 32MB rom to hold the game files.

Atari Wallets

June 12, 2009 by 30 Comments

[youtube=http://www.youtube.com/watch?v=fbpq8NEWxYc]
[niles] has refined the art of making wallets out of game cartridges. Specifically, he is using Atari cartridges. He’s gotten down to about a two hour process which results in a decently usable wallet. We’ve seen someone make a cartridge wallet before, and we have to ask the same question; who wants to carry this around in their pocket?

[thanks yuppicide]

CrossCanada: A Biking Documentary

June 9, 2009 by 25 Comments

bike_arm

[Mike] was going to be biking across Canada. He really wanted to document the trip, so he began planning ways to get still images taken at intervals along the way. After a bit of brainstorming, he ended up setting his goals a bit higher. He was going to film the entire trip. He really didn’t want a simple helmet cam, he wanted himself and the entire bike in the frame. To do this he had to build a long arm on which he mounted a bullet cam. On his handlebars, he has a simple control where he can turn the system on and off as well as initiate recording.

No single piece of this project was too complicated, but taken all together, the final result is quite nice. You can watch the video for yourself after the break.

Continue reading “CrossCanada: A Biking Documentary” →

Graduation Cap Diorama

June 6, 2009 by 29 Comments

[youtube=http://www.youtube.com/watch?v=XmTGh76nUfU]

[Roland] recently graduated from UC Berkely. For his graduation ceremony, he wanted to do something unique. He built a diorama on his graduation cap depicting a house driven from alternative energy. The whole thing is solar powered. The wind turbine is actually powered from the solar panel, and with a remote control, he can make the sun rise and set.

Goggle Camera Mod

May 19, 2009 by 21 Comments

finished-goggles (Custom)

[Will] submitted his ski goggle mod. He has mounted an Oregon Scientific ATC3K digicam in his goggles. This should make recording ski trips a lot easier. Most of the electronics fit just fine in the mask, though he did need to use an IDE cable to extend parts of it to the custom pack mounted on the strap. We’re also curious how much wind noise he’s going to get on that microphone.