Parts: Unboxing The Bus Pirate

July 20, 2009 by Ian 43 Comments

bp-unbox-3

For months we’ve used our Bus Pirate universal serial interface tool to demonstrate electronics parts, so it’s only appropriate that the Bus Pirate get it’s own parts post. We recently had a Bus Pirate preorder, and today we received the pre-production Bus Pirate prototype from Seeed Studio. This prototype was mailed just a few days before preorder 1 started to ship, so those packages should start arriving any day.

Follow along as we unbox the prototype Bus Pirate, and connect it to a debugger to determine the PIC24FJ64GA002-I/SO revision that shipped with this board. Use this post to share your own Bus Pirate unboxing experience. Pictures and discussion after the break.

Continue reading “Parts: Unboxing The Bus Pirate” →

Parts: 4×20 VFD Character Display (NA204SD02)

July 13, 2009 by Ian 24 Comments

futuba-serial

Futaba makes vacuum florescent character displays that can be used as a drop-in replacement for common character LCDs. VFDs have a wider viewing angle, and generally look cooler.

Futaba’s character displays can be interfaced using the standard 8-bit or 4-bit parallel LCD interface, or a simple two-wire protocol. The protocol type is set by resistors on the back of the display, so it’s not particularly easy to change without a hot-air rework station. Today we’ll demonstrate a serially-interfaced VFD using the Bus Pirate.

Continue reading “Parts: 4×20 VFD Character Display (NA204SD02)” →

Photo Interrupters Explained

July 12, 2009 by Caleb Kraft 20 Comments

img_0147 (Custom)

[Eric] sent in this very informative writup on how to use Photo interrupters. These things can be used for many things, he lists pellet dispensing and limit switches. He found one in his junk box and realized he knew very little about it. After some exploring and research, he’s here to educate the rest of us. There’s a good breakdown of the circuit itself which is pretty simple as well as a test circuit and some sample code.

Parts: Ferrite Beads

July 6, 2009 by Ian 34 Comments

ferrite-bead.ii

Ferrite beads (L1 in the photo) filter high frequency power supply noise by converting it into a tiny amount of heat. Power supply noise can cause various problems for many parts, especially in analog audio and display circuits.

Ferrite beads are simple, but choosing one can be confusing because they’re not commonly used by hobbyists. Most designs will still work if you omit the ferrite bead(s), but beads are so cheap there’s no reason to sacrifice the added reliability they provide. We describe how we pick ferrite beads for our projects after the break.

Continue reading “Parts: Ferrite Beads” →

Parts: SPI EEPROM (25AA/25LC)

June 30, 2009 by Ian 11 Comments

3EEPROM-SPI

Microchip’s 25AA/25LC EEPROMs are data storage chips with a simple 3-wire interface. The 25AA/LC is an SPI version of the common 24AA/LC I2C EEPROM. It comes in capacities of 128bytes to 128kilobytes. We looked at the smallest, the 128byte 25AA010A.

There are Bus Pirate demonstrations for most types of serial EEPROMs. Check out our previous 1-wire (DS2431) and I2C (24LC1025) EEPROM posts.

Continue below to see our test circuit and a demonstration of the 25AA010 EEPROM. We used the Bus Pirate to play with this chip from our PC. For a limited time you can get your own Bus Pirate, fully assembled and shipped worldwide, for only $30.

Continue reading “Parts: SPI EEPROM (25AA/25LC)” →

Parts: ShiftBrite RGB LED Module (A6281)

June 29, 2009 by Ian 11 Comments

shiftbriteii

Macetech’s ShiftBrite is a high-power RGB LED coupled with an Allegro A6281 backpack. The A6281 uses three 10bit pulse-width modulators to mix millions of colors using the red, green, and blue elements in the RGB LED. Multiple modules can be chained together for bigger projects, like the ShiftBrite table.

Below the break we demonstrate a ShiftBrite module using the Bus Pirate. For a limited time you can get your own Bus Pirate, fully assembled and shipped worldwide, for only $30.

Continue reading “Parts: ShiftBrite RGB LED Module (A6281)” →

Parts: I2C Real-time Clock Calendar (PCF8563)

June 26, 2009 by Ian 8 Comments

The PCF8563 is a real-time clock/calendar/alarm chip with an I2C interface. This would be useful in projects where the primary microcontroller doesn’t have enough resources for an interrupt driven clock.

We demonstrate the PCF8563 using the Bus Pirate after the break. For a limited time you can get your own Bus Pirate, fully assembled and shipped worldwide, for only $30.

Continue reading “Parts: I2C Real-time Clock Calendar (PCF8563)” →