Building New Interfaces With An IPad

April 22, 2012 by Brian Benchoff 9 Comments

There’s a word – synchronicity – to describe two disparate events that occur together in a meaningful way. We see this a lot in the Hackaday tip line; two people send in somewhat similar hacks solving similar problems in similar ways nearly simultaneously. Here’s two builds by [Bryce] and [spektakx] that hit our inbox within minutes of each other that both implement existing interfaces with iPads.

iPad turntable controller

[spektakx] sent in an iPad powered DJ MIDI controller he built as a prototype to test out the size, orientation and layout for an upcoming build. The turntable controllers are simple USB affairs made to jog and scratch records digitally. Although [spektakx] admits it’s a little unfinished, it’s still just a prototype. Also, he can use a Windows 7 tablet laptop for ‘more suited’ hardware. Check out [spektakx]’ video demo after the break.

an iPad cash register

[Hacktheory] found [Bryce]’s Flickr photolog of a DIY ‘Square’ cash register. The electronics part of this build is practically non-existent; it’s just an iPad with a credit card readers that plugs into the headphone jack. Yes, we just saw these ‘Square’ credit card readers this last week. The fabrication portion of this build is incredible – [Bryce] has a few wonderful pieces of walnut there, and did an exceptional job with the wood work. It’s probably not well suited to high-volume retail, but we couldn’t think of a better cash register for a boutique shop.

Continue reading “Building New Interfaces With An IPad” →

Miniaturized N64 Controller Fits The Tiniest Of Hands

April 22, 2012 by Mike Nathan 27 Comments

n64-controller-mod

The controllers that came with the Nintendo 64 don’t exactly measure up to the “Duke” of Xbox fame, but they’re not the smallest in the world either. Made by Bacteria forum member [Bungle] says that his girlfriend has incredibly tiny hands, so he thought he might try trimming some of the fat from an N64 controller by cramming its components into an N64 cartridge.

He tore down a 3rd-party N64 controller, tossing out the D-Pad, plug, and rumble motor, retaining all of the other buttons. After gutting the game cartridge, he heated the back side under a lamp and stretched the plastic over a roll of electrical tape to make room for the N64’s trademark “Z” button. Having only removed the rumble motor due to size constraints, he found a suitable replacement at Radio Shack, which fills in for the original nicely.

After a good amount of careful trimming, wiring, and mounting, he came up with the little gem you see above. We’re sure [Bungle’s] girlfriend is pleased with his work, and he seems happy with how it came out as well.

Continue reading to see a short video showing off [Bungle’s] latest creation.

[Thanks, Chris Downing]

Continue reading “Miniaturized N64 Controller Fits The Tiniest Of Hands” →

Slow Motion Destruction Of Random Things

April 22, 2012 by Caleb Kraft 21 Comments

Though we can’t really tell you how this is hacking related, we’ve always shared random videos of stuff getting destroyed with you. Invariably someone in the comments goes on a rant about how wasteful and/or dangerous it is. This clip, from a Danish TV show called Stupid and Dangerous, fits that description quite well. It is also freaking awesome.

We’re really not sure what draws us to these videos exactly. Is it vicarious destruction or possibly our natural affinity for slow motion?

[via Dvice]

http://www.youtube.com/watch?v=lUZ-e2SkeMI

Sassy Disco Bots Of The 80s

April 22, 2012 by Caleb Kraft 18 Comments

Surely, this is a glimpse into the future. No? Ok, its a glimpse into 1983. A small chinese fast-food restaurant in California put two 4.5 foot tall, 180 pound robots to work delivering food. Tanbo R-1 and Tanbo R-2 were their names and delivering food was their game. At least, when there wasn’t radio interference or their batteries were running low. They were built to deliver food to the tables and be polite to the customers. They also had some interesting quirky behavior, like responding “that’s not my problem” and dancing off to some disco music if they didn’t understand you. Do yourself a favor and go read some of the stories. We wish we could have seen them in action, they sound fantastically absurd.

An Easy To Build Cat Feeder Driven By A DIY Linear Actuator

April 21, 2012 by Mike Nathan 15 Comments

[Will Finucane] of Revolt Labs/Mad Science Blog was looking for a way to keep his cats happily fed while away on a short vacation, so he put together a cheap and easy automatic feeder to ensure that his pets didn’t go hungry while he was away.

We’ve seen different iterations of automatic pet feeders here before, some relying on rotating false bottoms, while others use crank-style feeders to get the job done. [Will’s] solution is a bit different, employing a cheap linear actuator to deliver feedings.

He emptied out a glue stick, replacing the glue with a brass tube. This gives him the rigidity that the glue lacked, allowing him to easily move a platform full of cat food up and down. He mounted the glue stick on a continuous rotation servo, installing the actuator and a feeding platform inside a cardboard box.

Using an Arduino, he lowers the movable platform every 12 hours, allowing a bit of cat food to fall from the hole he cut in the side of the box. While his creation might not stand up to years of use, it’s a quick solution that can cost very little, depending on what you have sitting around.

Check out the video below to see [Will’s] cat feeder in action.

Continue reading “An Easy To Build Cat Feeder Driven By A DIY Linear Actuator” →

Visible Kitteh Project Keeps Mice Out Of The House

April 21, 2012 by Brian Benchoff 28 Comments

[Aaron] and his wife have a wonderful cat that likes to contribute to the household by bringing field mice, shrews, and voles into the house as a ‘present.’ Obviously, this leads blood, fur, and viscera staining the carpet, and chasing around mortally wounded rodents isn’t [Aaron]’s idea of fun. To stop the cat from bringing small mammals into the house, [Aaron] is now preventing the cat from entering the house when it has an animal in its mouth.

[Aaron]’s project is inspired by this facial recognition cat door that refuses entry of all cats holding a small rodent in their mouth. To get his system working, [Aaron] started researching object recognition and built an Android app using the OpenCV libraries. To detect if his cat has a rodent in his mouth, [Aaron] is using Harr cascades – a proven object detection system that will detect and differentiate between a cat and a cat plus mouse.

Right now, the project is only about half done. [Aaron] is currently training his object recognition system, a process that can take days. Still, anything that keeps mouse guts out of the carpet is an awesome project in our books.

Science And Engineering Festival Comes To DC

April 21, 2012 by Brian Benchoff 5 Comments

If you’re around the Washington, DC metro area next weekend, here’s something for you. It’s the USA Science and Engineering festival, and if you’ve ever wanted to talk to [Adam] and [Jamie] from Mythbusters, [Bill Nye], and several astronauts, this is where you should be next weekend.

This is the second USA Science and Engineering festival. The first festival, brought to bear because of an act of congress. The last festival was highly successful (and fun), so we can’t wait to see the reports from next weekend roll in. This time around, there will be scale models of the Orion Service Module, an F-22 cockpit Demonstrator, and a demonstion of an F-35 taking off vertically. Yep, Lockheed Martin is hosting this festival, but it’s still cool.

Even though the website makes it seem this festival is geared towards children, we’re sure we’d have a blast visiting. Here’s a solution: borrow a niece or nephew and show them what engineering can do.

We have to note you can also visit the NASA Goddard Space Flight Center while you’re in DC. It’s just a short Metro ride (with a bus transfer) from the convention center where the festival will be taking place. We highly recommend the tour of the facility. If anyone knows if you can see the space shuttles Discovery and Enterprise at the Udvar-Hazy center next weekend, drop us a line. We’ll amend our DC ‘look at cool stuff’ recommendations.

Tip ‘o the hat to [Paul] for sending this one in.