Parachute Drops Are Still A Viable Solution For Data Recovery From High Altitude Missions

December 19, 2023 by 12 Comments

Once upon a time, when the earliest spy satellites were developed, there wasn’t an easy way to send high-quality image data over the air. The satellites would capture images on film and dump out cartridges back to earth with parachutes that would be recovered by military planes.

It all sounds so archaic, so Rube Goldberg, so 1957. And yet, it’s still a viable method for recovering big globs of data from high altitude missions today. Really, you ask? Oh, yes indeed—why, NASA’s gotten back into the habit just recently!

Continue reading “Parachute Drops Are Still A Viable Solution For Data Recovery From High Altitude Missions” →

Creating An Automated Hydrogen Generator At Home

October 6, 2023 by 33 Comments

Everyone and their pet hamster probably knows that the most common way to produce hydrogen is via the electrolysis of water, but there are still a number of steps between this elementary knowledge and implementing a (mostly) automated hydrogen generator. Especially if your end goal is to create liquid hydrogen when everything is said and done. This is where [Hyperspace Pirate]’s latest absolutely not dangerous project commences, with the details covered in the recently published video.

Automated hydrogen generator setup, courtesy of [Hyperspace Pirate]'s dog drinking bowl.
Automated hydrogen generator setup, courtesy of [Hyperspace Pirate]’s dog drinking bowl.
Since electrolysis cannot occur with pure water, sodium hydroxide (NaOH) is used in the solution to provide the ions. The electrodes are made of 316 stainless steel, mostly because this is cheap and good enough for this purpose. Although the original plan was to use a stacked series of electrodes with permeable membranes like in commercial electrolysers, this proved to be too much of a hassle to seal up leak-tight. Ergo the demonstrated version was attempted, where an upturned glass bell provides the barrier for the produced hydrogen and oxygen. With this system it’s easy to measure the volume of the produced hydrogen due to the displaced water in the bell.

Once enough hydrogen gas is produced, a vacuum pump is triggered by a simple pair of electrodes to move the hydrogen gas to a storage container. Due to hydrogen embrittlement concerns, an aluminium tank was used rather than a steel one. Ultimately enough hydrogen gas was collected to fill a lot of party balloons, and with the provided information in the video it should be quite straightforward to reproduce the system.

Where the automation comes into play is with a control system that monitors for example how long the vacuum pump has been running, and triggers a fail safe state if it’s more than a set limit. With the control system in place, [Hyperspace Pirate] was able to leave the hydrogen generator running for hours with no concerns. We’re hopeful that his upcoming effort to liquify this hydrogen will be as successful, or the human-rated blimp, or whatever all this hydrogen will be used for.

Continue reading “Creating An Automated Hydrogen Generator At Home” →

Hackaday Links Column Banner

Hackaday Links: September 24, 2023

September 24, 2023 by 3 Comments

Modern video games are almost always written on the backs of a game engine platform, and the two most popular are definitely Unreal Engine and Unity. Some bean counter at Unity decided they essentially wanted a bigger piece of the pie and rolled out new terms of use that would have game development houses paying per Unity install. This was a horrible blow to small indie game development houses, where the fees would end up eating up something like 15% of revenue in an industry that’s already squeezed between the Apple Store and Steam. It caused an absolutely gigantic uproar in the game dev community, and now Unity is walking it back.

We noticed the change first because tons of “migrate from Unity to Godot” tutorials popped up in our YouTube stream. Godot is a free and open-source game engine, and while we’re no game devs, it looks to be at about the level of Blender five years ago – not quite as easy to use or polished as its closed-source equivalents, but just about poised to make the transition to full usability. While we’re sure Unreal Engine is happy enough to see Unity kick some more business their way, we’re crossing our fingers for the open-source underdog.

Amazon’s Kindle Direct Publishing allows independent authors to self-publish. And it’s apparently been awash in prose written by large language models. While it was fun for a while to look through self-published books for the shibboleth phrase “As an AI language model,” Amazon caught on pretty quickly. Of course, that only gets the lowest-hanging fruit. Books like the AI-written guidebook to mushrooms that recommends eating the Death Cap still manage to sneak through, as we mentioned two weeks ago.

Amazon’s solution? Limiting self-published books to three per day. I wrote a book once, and it took me the better part of a year, and Amazon is letting through three per day. If this limit is going to help limit the size of the problem, then we vastly underestimate the problem.

And it’s good news, bad news from space. The good news is that NASA’s OSIRIS-REx mission to return a sample from the asteroid Bennu successfully landed just a few hours ago. As we write this, they’ve sent a team driving around the Utah desert to pick up the capsule. The effort reminds us of retrieving high-altitude balloon capsules after a flight: you know roughly where it is, but you still have to get out there to fetch it.  Only NASA has a helicopter to go out looking for the capsule and a lot more science to do before they can throw it in the back of their car.

On the bad news side, India’s Vikram and Pragyan lunar lander/rover pair wasn’t really expected to make it through the long lunar night and had successfully executed all of its planned mission goals before going into deep sleep mode two weeks ago. But you’ve got to try to wake it up anyway, right? Well, the sun came up on Vikram on Friday, and the Indian space agency tweeted a stoic, “Efforts have been made to establish communication with the Vikram lander and Pragyan rover to ascertain their wake-up condition. As of now, no signals have been received from them. Efforts to establish contact will continue.” We’ve still got our fingers crossed, but at this point it would just be extra icing on the cake.

Giving Solar Power’s Mortal Enemies A Dusting Without Wasting Water

August 16, 2023 by 28 Comments

A prerequisite for photovoltaic (PV) and concentrated solar power (CSP) technologies to work efficiently is as direct an exposure to the electromagnetic radiation from the sun as possible. Since dust and similar particulates are excellent at blocking the parts of the EM spectrum that determine their efficiency, keeping the panels and mirrors free from the build-up of dust, lichen, bird droppings and other perks of planetary life is a daily task for solar farm operators. Generally cleaning the panels and mirrors involves having trucks drive around with a large water tank to pressure wash the dirt off, but the use of so much water is problematic in many regions.

Keeping PV panels clean is also a consideration on other planets than Earth. So far multiple Mars rovers and landers have found their demise at the hands of Martian dust after a layer covered their PV panels, and Moon dust (lunar regolith) is little better. Despite repeated suggestions by the peanut gallery to install wipers, blowers or similar dust removal techniques, keeping particulates from sticking to a surface is not as easy an engineering challenge as it may seem, even before considering details such as the scaling issues between a singular robot on Mars versus millions of panels and mirrors on Earth.

There has been research into the use of the electrostatic effect to repel dust, but is there a method that can keep both solar-powered robots on Mars and solar farms on Earth clean and sparkling, rather than soiled and dark?

Continue reading “Giving Solar Power’s Mortal Enemies A Dusting Without Wasting Water” →

Hackaday Links Column Banner

Hackaday Links: May 21, 2023

May 21, 2023 by 14 Comments

The reports of the death of automotive AM radio may have been greatly exaggerated. Regular readers will recall us harping on the issue of automakers planning to exclude AM from the infotainment systems in their latest offerings, which doesn’t seem to make a lot of sense given the reach of AM radio and its importance in public emergencies. US lawmakers apparently agree with that position, having now introduced a bipartisan bill to require AM radios in cars. The “AM for Every Vehicle Act” will direct the National Highway Transportation Safety Administration to draw up regulations requiring every vehicle operating on US highways to be able to receive AM broadcasts without additional fees or subscriptions. That last bit is clever, since it prevents automakers from charging monthly fees as they do for heated seats and other niceties. It’s just a bill now, of course, and stands about as much chance of becoming law as anything else that makes sense does, so we’re not holding our breath on this one. But at least someone recognizes that AM radio still has a valid use case.

Continue reading “Hackaday Links: May 21, 2023” →

Launching Paper Planes From Way, Waaaaaay Up

May 7, 2023 by 13 Comments

Every now and again we stumble across something a bit unexpected, and today that’s the fact that there have been quite a few efforts at launching paper planes from as close to space as possible. The current record for the highest paper plane launch is a whopping altitude of 35,043 meters.

That altitude is considerably short of what would be called “space”, but it’s still an awfully long way up and the air there is very thin compared to on the surface. Space is generally (but not universally) considered to be beyond 100 km above sea level, a human-chosen boundary known as the Kármán line. 35 km is a long ways into the stratosphere, but still within Earth’s atmosphere.

Even so, that doesn’t mean there haven’t been efforts to go considerably higher. There was a Japanese proposal to drop airplanes made from special heat-resistant paper from the International Space Station, roughly 400 km above Earth. Success would show that low-speed, low-friction atmospheric reentry is feasible — for pieces of paper, anyway. But one of the challenges is the fact that there is no practical way to track such objects on their way down, and therefore no way to determine where or when they would eventually land.

There have been many other high-altitude paper plane launches, but the current record of 35,043 meters was accomplished by David Green in the United Kingdom as part of a school project. Such altitudes are in the realm of things like weather balloons, and therefore certainly within the reach of hobbyists.

As for the airplanes themselves, the basic design pictured here probably won’t cut it, so why not brush up on designs with the Paper Airplane Design Database? Even if you don’t send them into the stratosphere (or higher), you might find something worth putting through a DIY wind tunnel to see how they perform.

FOSDEM 2023: An Open-Source Conference, Literally

March 1, 2023 by 6 Comments

Every year, on the first weekend of February, a certain Brussels university campus livens up. There, you will find enthusiasts of open-source software and hardware alike, arriving from different corners of the world to meet up, talk, and listen. The reason they all meet there is the conference called FOSDEM, a long-standing open-source software conference which has been happening in Belgium since 2000. I’d like to tell you about FOSDEM because, when it comes to conferences, FOSDEM is one of a kind.

FOSDEM is organized in alignment with open-source principles, which is to say, it reminds me of an open-source project itself. The conference is volunteer-driven, with a core of staff responsible for crucial tasks – yet, everyone can and is encouraged to contribute. Just like a large open-source effort, it’s supported by university and company contributions, but there’s no admission fees for participants – for a conference, this means you don’t have to buy a ticket to attend. Last but definitely not least, what makes FOSDEM shine is the community that it creates.

FOSDEM’s focus is open software – yet, for hackers of the hardware world, you will find a strong hardware component to participate in, since a great number of FOSDEM visitors are either interested in hardware, or even develop hardware-related things day-to-day. It’s not just that our hardware can’t live without software, and vice-versa – here, you will meet plenty of pure software, a decent amount of pure hardware, and a lot of places where the two worlds are hard to distinguish. All in all, FOSDEM is no doubt part of hacker culture in Europe, and today, I will tell you about my experience of FOSDEM 2023. Continue reading “FOSDEM 2023: An Open-Source Conference, Literally” →