Driving A Motor With An Audio Amp Chip

September 18, 2023 by 25 Comments

[InazumaDenki] wanted to answer the question: can you drive a motor with an audio amplifier chip? The answer, of course, is yes. The TDA7052 has a single input, and a bridge output meant to drive a speaker differentially. It should work if the motor doesn’t present more of a load than a speaker.

The plan was to use a resistive divider to provide several discrete voltages to the input. At precisely the half-way mark, there should be no voltage across the load. Altering the input to go higher than halfway should make the motor turn one way, and making it go lower should turn the motor the other way. As you can see in the video below, it does work, although it may not be ideal for this application.

Continue reading “Driving A Motor With An Audio Amp Chip” →

Simulating A Real Perpetual Motion Device

September 18, 2023 by 25 Comments

Perpetual motion and notions of ‘free energy’ devices are some of those pseudo-science topics that seem to perpetually hang around, no matter how many times it is explained how this would literally violate the very fabric of the Universe. Even so, the very notion of a device which repeats the same action over and over with no obvious loss of energy is tempting enough that the laws of physics are employed to effect the impossible in a handy desktop format. This includes the intriguing model demonstrated by [Steve Mould] in a recent video, including a transparent version that reveals the secret.

This particular perpetual motion simulator is made by [William Le] and takes the form of metal balls that barrel down a set of metal rails which turn upward so that each metal ball will land back where it started in the top bowl. To the casual informed observer the basic principle ought to be obvious, with magnetism being a prime candidate to add some extra velocity to said metal ball. What’s less obvious is the whole mechanism that makes the system work, including the detection circuit and the tuning of the parameters that tell the device when its electromagnet should be on or off.

When [Steve] figured that he could just make a transparent version using the guts from the one he purchased, he quickly found out that even with [William]’s help, this wasn’t so easy. Ultimately [William] hand-crafted a transparent version that shows the whole system in its entire glory, even if this is somewhat like demonstrating a magic trick in an easy to follow manner.

Continue reading “Simulating A Real Perpetual Motion Device” →

What Is Killing Cursive? Ballpoints. Probably.

September 18, 2023 by 225 Comments

I get it — you hate writing by hand. But have you ever considered why that is? Is it because typing is easier, faster, and more convenient here in 2023? Maybe so. All of those notwithstanding, I honestly think there’s an older reason: it’s because of the rise of ballpoint pens. And I’m not alone.

Bear with me here. Maybe you think you hate writing because you were forced to do it in school. While that may very well be, depending on your age, you probably used a regular wood-case pencil before graduating to the ballpoint pen, never experiencing the joys of the fountain pen. Well, it’s never too late.

Continue reading “What Is Killing Cursive? Ballpoints. Probably.” →

Satellite Hunting Hack Chat

September 18, 2023 by 5 Comments

Join us on Wednesday, September 20 at noon Pacific for the Satellite Hunting Hack Chat with Scott Tilley!

From the very first beeps of Sputnik, space has primarily been the domain of nations. It makes sense — for the most part, it takes the resources of a nation to get anything of appreciable size up out of the gravity well we all live in, but more importantly, space is the highest of high ground, and the high ground has always been a place of advantage to occupy. And so a lot of the hardware we’ve sent upstairs in the last 70 years has been in the national interest of this or that country.

join-hack-chatA lot of these satellites are — or were, at least — top secret stuff, with classified payloads, poorly characterized orbits, and unknown communications protocols. This can make tracking them from the ground a challenge, but one that’s worth undertaking. Scott Tilley has been hunting for satellites for years, writing about his exploits on the Riddles in the Sky blog and sometimes being featured on Hackaday. After recently putting his skills to work listening in on a solar observation satellite as its orbit takes it close to Earth again, we asked him to stop by the Hack Chat to share what he’s learned about hunting for satellites, both long-lost and intentionally hidden. Join us as we take a virtual trip into orbit to find out just what’s going on up there.

Our Hack Chats are live community events in the Hackaday.io Hack Chat group messaging. This week we’ll be sitting down on Wednesday, September 20 at 12:00 PM Pacific time. If time zones have you tied up, we have a handy time zone converter.

A silver front loader cargo bike sits in a parking lot in front of an electric vehicle charger. A cable runs from the charger to the bike.

Fast Charging A Cargo Bike From An Electric Car Charger

September 18, 2023 by 15 Comments

Fast charging is all the rage with new electric cars touting faster and faster times to full, but other EVs like ebikes and scooters are often left out of the fun with exceedingly slow charging times. [eprotiva] wanted to change this, so he rigged up a fast charging solution for his cargo bike.

Level 2 electric vehicle chargers typically output power at 7 kW with the idea you will fill up your electric car overnight, but when converted down to 60 V DC for a DJI Agras T10 battery, [eprotiva] is able to charge from 20% to 100% capacity in as little as 7 minutes. He originally picked this setup for maxing the regen capability of the bike, but with the high current capability, he found it had the added bonus of fast charging.

The setup uses a Tesla (NACS) plug since they are the most plentiful destination charger, but an adapter allows him to also connect to a J1772 Type 1 connector. The EV charging cable is converted to a standard 240 V computer cable which feeds power to a drone charger. This charger can be set to “fast charge” and then feeds into the battery unit. As an added bonus, many chargers that do cost money don’t start charging until after the first five minutes, so the bike is even cheaper to power than you’d expect.

For some reason, you can watch him do this on TikTok too.

If you too want to join the Personal EV Revolution, be sure to checkout how to choose the right battery for your vehicle and a short history of the Segway.

The Challenge Of Weather Modification In The Face Of Climate Change

September 18, 2023 by 80 Comments

Over the past decades we have been able to observe a change in the Earth’s climate, caused by an increasing amount of energy being retained in the atmosphere. This in turn has affected weather systems around the globe, causing more extreme weather. As a result, the prospect of weather control is more relevant than ever for the nations which are most directly impacted by severe rain and winds.  Although the concept of weather modification is not new, it used to be primarily focused on rather limited aspects, such as cloud seeding to increase precipitation.

Recent proposals such as Japan’s weather modification moonshot program seek to find ways to prevent or lessen the impact of torrential rains, typhoons and similar extreme weather events which accompany climate change.  This proposal is part of Japan’s multi-topic Moonshot R&D program which seeks to advance the state of the art in a wide range of fields in a very significant way by 2050. As far as weather modification is concerned, this naturally raises many questions. Clearly we are capable of affecting the climate through emissions of e.g. greenhouse gases and large-scale construction, but are there ways in which humans can affect the climate and weather in a more refined manner that benefits society, or is this something which will remain beyond our grasp for the foreseeable future?

Continue reading “The Challenge Of Weather Modification In The Face Of Climate Change” →

Sailor Hat Adds Graceful Shutdown To Pis

September 18, 2023 by 45 Comments

Even though Windows and other operating systems constantly remind us to properly eject storage devices before removing them, plenty of people won’t heed those warnings until they finally corrupt a drive and cause all kinds of data loss and other catastrophes. It’s not just USB jump drives that can get corrupted, though. Any storage medium can become unusable if certain actions are being taken when the power is suddenly removed. That includes the SD cards on Raspberry Pis, too, and if your power isn’t reliable you might consider this hat to ensure they shut down properly during power losses.

The Raspberry Pi hat is centered around a series of supercapacitors which provide power for the Pi temporarily. The hat also communicates with the Pi to let it know there is a loss of power, so that the Pi can automatically shut itself down in that situation to prevent corrupting the memory card. The hat is more than just a set of backup capacitors, though. The device is capable of taking input power from a wide range of sources and filtering it for the power requirements of the Pi, especially in applications like boats and passenger vehicles where the input power might be somewhat noisy. There’s an optocoupled CAN bus interface as well for those looking to use this for automotive applications.

The entire project is also available on the project’s GitHub page for those wishing to build their own. Some sort of power backup is a good idea for any computer, though, not just Raspberry Pis. We’ve seen uninterruptible power supplies (UPS) with enough power to run an entire house including its computers, to smaller ones that’ll just keep your Internet online during a power outage.

Continue reading “Sailor Hat Adds Graceful Shutdown To Pis” →